NDT for tubes & pipes

Uses axial scanning on free-standing pipes with none or light coatings (<3-4mm) for fast and accurate defect detection around the circumference of the pipe.

Axial and/or Circumferential scanning to detect and measure corrosion under pipe supports.

Side inspection is used for the detection of defects in inaccessible areas up to 3m (10’) from the sensor.

Fast inspection for detection of surface defects on most metallic materials.

LRUT provides long-range inspections of pipes covering up to 100m per side (200m total). It uses the same instrument and complements MRUT for inspection of pipes at any distance.

EMAT sensors permit non-contact and no-couplant measurements from -30ºC to 650ºC on most metallic materials. DCUT sensors provide no-couplant measurements for metallic and non-metallic components.

Measurement of bolt-load by comparing variations in ultrasonic Time-Of-Flight corresponding to changes in bolt elongation (strain). Single (SH) wave and double (SH + L) wave sensors available to meet different requirements.

Semi-automated system for thickness measurement and Hydrogen Corrosion Cracking (HCC) for boiler tube walls.

Residual stress measurement on railroad wheels, pipelines, and steel plates using custom sensors, software, and positioners.